SawStop®OWNER’S MANUALPremium Fence Assembly
SawStopFig. 1615. The holes in the bottom of the front rail are oversized to allow you to adjust the position of the main tube on the rail. To set th
17. Once the fence is tightly clamped to the main tube, move the left end of the main tube back toward the saw until there is only a small gap (appro
Adjusting Your Rip FenceFig. 19right indicatorleft indicatorThe fence allows you to precisely set the width of your rip cuts (cuts that are length-wis
Adjusting Your Rip FenceThe next step is to align the face plates to be parallel to the miter slots. Begin by sliding the fence alon
Adjusting Your Rip FenceYou may nd that after adjusting the face plates the end of the cross-bracket has been raised or lowered such that it i
The rip fence included with your Premium Fence Assembly is used to guide material parallel to the blade when you make rip cuts (cuts that are length-w
14 SawStop Premium Fence AssemblySawStop12543678910111212121213141545161717181819192122262425202027Premium Rip Fence Exploded View
SawStop Premium Fence Assembly 15No. Description Part No. Qty.Premium Rip Fence (items 1-27) PFA-RF 11 Fence Tube PFA-001 12 Fence Head PFA-002 13
Premium Rails and Extension Table Assembly Exploded View16 SawStop Premium Fence Assembly1009 01 02 03 04 05 006 07 08 09 01 02 03 04 05 06 07 08 0
SawStop Premium Fence Assembly 17Premium Rails and Extension Table Assembly Parts ListNo. Description Part No. Qty.1 M8x1.25x16 Flat Head Socket Bo
1. You must install a rip fence before using your saw. Attempting to use the saw without the rip fence could result in serious personal injury.2. Al
SawStop, LLC9564 S.W. Tualatin RoadTualatin, Oregon 97062www.sawstop.comMain Phone - (503) 570-3200Service - (503) 582-9934Fax - (503) 570-3303Email:
Unpacking Your Fence AssemblyWhile unpacking your fence assembly, verify that all of the components on this page are included. Use care when unpacking
11. Before you begin installing the Premium Fence Assembly, locate the front rail, the rear rail, and the fence assembly hardware pack (see Fig. 1).
2543SawStopSystem Status CodesStatusRedGrn¯¯¯Wet WoodOverload Due To During BypassContact DetectedDuring StandbyContact Detected BrakeAdjust Position
!WARNINGMoving gears and parts can pinch, cut or crush.Do not operate withdoor open.121314151212Fig. 6!WARNINGMoving gears and partscan pinch, cut or
Fig. 88. Use a straight-edge to level the rear edge of the left extension wing to the cast iron table top (see Fig. 8). You may have to pull
10. The extension table mounts to the rails with bolts that pass through holes in the rails and extension table. Take four M8x1.25x
43 613. Locate the main tube and remove seven M8x1.0x16 hex head bolts, seven M8x23x2 washers, and seven M8 lock washers from the fence
Commentaires sur ces manuels