®0153045SawStop10” Contractor SawSawStopQuick StartGuide10” Contractor Saw
101. Turn the saw OFF and unplug the power cord.2. Set the blade to 0°, raise it fully and remove the table insert. 3. Remove the blade
11Adjusting the Blade-to-Brake Spacing Always adjust the blade-to-brake spacing after installing a blade or brake cartridge. See Owner’s Manual?p
12See Owner’s Manual?pp.53-551. Turn the saw OFF and unplug the power cord. 2. Set the blade to 0°, raise it fully and remove the table insert
13If the brake has activated, remove the brake and blade together by “walking” the blade and brake off the arbor and mounting pins. To “w
2What are you cutting?If you don’t know whether the material you are about to cut is conductive, perform the material conductivity test on page 5.Not
3To Run Saw in Normal Mode:If you are nished using the saw, ip themain power switch offafter the blade has cometo a complete stop.5. WARNING: Alw
4To Run Saw in Bypass Mode: 1.Flip the main power switch up to turn on power.ON OFF2.Wait until the greenlight is on steady andthe red lig
5Material Conductivity Test1. Start the saw in Bypass Mode. 2. Carefully make several cuts of the material.3. Check the red light before pushing
6Switch Box LightsOn Solid Slow Blink Fast Blink OFFSystem Startup - The system is performing self-checks. Allow 10 seconds to
7Push the Start/Stop Paddle to OFF - The saw will not start if the paddle is pulled out when the main power switch is turned on. Turn the Cartridge Ke
8Slide the table insert toward the blade at a slight angle. The screws in the bottom rear of the insert should slide under the h
9Changing the Riving Knife / Blade GuardPosition the blade guard or riving knife in the clamp.Fully lower the clamping handle.5. 6. Turn the saw OFF a
Commentaires sur ces manuels